We know that many small and medium-sized machining centers have application problems that are prone to malfunctions, and the problems caused by small machining centers have led to some operations.
The machine tool failure of the CNC system in the operation mode of CNC milling, namely manual mode, memory operation mode, MDI mode, and the method of returning to the reference point.
If a malfunction occurs during the operation of a small machining center program, the location of the malfunction in the program and the serial number of the program and program block are incorrect. What is the program content that failed in the program segment, what command was the failure, and whether there was a motion fault on the axis.
Whether it is in M or T code, it cannot be implemented. Whether it is the same, the same operational fault, and repeatedly check the fault. Whether it is a malfunction in data input.
When the feed axis or spindle fails. The faults related to the feed axis servo need to be analyzed whether they exist at low or high feed speeds, or only at the axis (by disconnecting the tested cable); For faults and spindles, it should be related to fault analysis (when something happens, CNC voltage switch of CNC milling machine, when speed, deceleration or normal operation).
|
