1. The tapping tip of the gear Angle Valve Machine is worn or the tension spring is loose. It should be checked whether the tapping tip of the gear Angle Valve Machine is worn and the force is uneven, and then check whether the tension spring is too loose or replaced with a new one.
2. The adjustment of the tapping belt of the Angle Valve Machine is not tight enough or the belt is damaged causing slipping. If the tapping triangle belt of the Angle Valve Machine is too loose, adjust the adjusting screw at the back of the machine to a suitable condition or replace it with a new belt.
3. The tapping belt of the Angle Valve Machine is too loose. Loosen the four small screws that fix the Angle Valve Machine. Then press the Angle Valve Machine down, and then tighten the four screws.
4. The brake electric power of the clutch is bad, you can replace the brake pads or replace the Angle Valve Machine.
5. The micro switch is broken, replace it with a new one. (How to replace the micro switch to be continued)
6. The cam stop switch is in the wrong direction. If it is started too slowly, it will also make the Angle Valve Machine unstable.
7.The data is deformed or there is too much residue in the chuck. You should check more information and organize more chucks.
Quanzhou Yueli Automation Equipment Co.,Ltd is a production enterprise led by Angle Valve Machine，Faucet making machine，Brass Punching Slot Machine,Cnc faucet making machine，Faucet assembling machine，Faucet Production Line ， You can contact us by email nina.h@yueli-tech.com.
|
