Daily maintenance method of core shooter
1. Always check whether the fastening bolts and nuts of each part are loose, and tighten them in time.
2. Clean the equipment after work every day, and clean inside and outside once a week.
3. Keep the electric control box and operation surface clean, and close the door tightly after non-overhaul or set time.
4. Check each cylinder, gas circuit and valve for leaks and eliminate them in time.
5. Clean the contact surface of moving parts at any time during work. Such as guide sleeve, guide post everywhere.
6. Keep the electric control box and operation surface clean. Close the door tightly after non-overhaul or set time.
Notes for core shooter
1. In equipment maintenance, inspection, adjustment, cleaning, etc. The main power supply and the main compressed air valve should be cut off.
2. After maintenance, inspection, and adjustment of the solenoid valve, it may not return to its original state. Pay attention to observation after powering on and ventilation to avoid accidental movement and danger.
3. All parts of the equipment should be stopped immediately when abnormal sounds, smells and other abnormal phenomena occur during operation. After checking and adjusting, a manual idling test run must be carried out first.
4. Before starting, check whether there are any guides in the moving parts and whether there are non-equipment operators approaching. Do not put tools and other debris on the equipment.
5. When the equipment is in operation, it is not allowed to touch the moving parts and electrical components.
6.When the equipment in operation suddenly stops working due to the interruption of external power supply, the power switch of the equipment should be cut off to avoid danger caused by re-energization.
|
